Bending springs Light Gauge UPVC ENGINEERING-HOME

We often hear about many problems that occur in homes due to errors in electricity, which sometimes result in disasters, and this is often due to errors in the process of establishing electricity in the house. The stage of establishing electricity is among the stages of finishing the apartment, in which the pipelines carrying all the cables are extended Electricity used for home appliances and lighting, air conditioning and all services that operate with electricity, and this stage is considered one of the most important stages because the error in it is not simple and it can cost you a lot.

As we know that the establishment of electricity takes place in 3 main steps, the first is the cracking of the walls, the ceiling and the floor to extend the places of pipes and hoses that contain the cables and the installation of cans in the walls, ceiling and floor, after that the stage of installing the cans in the 3 places previously mentioned and the installation of pipes or hoses that will be expanded Inside it are the cables, and at the last stage, pull the wires or cables inside the pipes and collect them in cans.

In order to ensure that your electricity is established on a correct basis, you must know what kind of pieces are suitable for your use, whether they are cans, pipes, or wires  .

In order to know the zipper of the pipes, we must first know

What are the electrical installation pipes:

Pipes are the channels in which cables run, and they are made of either metal or plastic, and whether they are rigid or flexible pipes, they protect cables and wires from any danger or external influences, so they are buried inside the wall to avoid any problems that occur to the wires and to them.

Plastic pipes are often the preferred choice in establishing electricity

Zipper:

• They are accessories for electrical conduits

How to use and implement:

Sometimes ready-made elbows are not used, but the elbow is implemented on site using an installation zipper, and it is used to bend the pipe according to the required angle in the site, where a rope end is attached to the ring at the beginning of the zipper, and the zipper is pulled using the rope into the pipe until the place where the elbow is intended to be made in the pipe, then The elbow is made at the required angle, and upon completion, the zipper is pulled from the inside of the pipe by pulling the rope

• The zipper of the installation of the engineering house UPVC pipe is of light thickness
• Brand  :  ENGINEERING-HOME | Engineering House
• It is accessories and tools for electric pipes.
• Sizes: 20 – 25 – 32 – 40 – 50 – 63 mm
• Made of UPVC material
• It is used to bend the pipe according to the required angle
• long term